Hello, I recently bought speedport 4r with speed home wifi gen 2 mesh repeater.

After setting up the router when i try to connect the speedhome wifi to the touer the connection is not possible.

Steps i Did:

1. Speedport is powered and connected to internet, speedhome wifi is powered
2. After router is setup and connected to internet, i press the "+" button on the router and the router starts searching for new devices to connect.(visible on the display that it is searching)
3. After powering the speedhome wifi, "+" was pulsing with green light. Then i press the "+" on the speed home wifi quickly(less than 10 secs between pressing it on router and the mesh repeater)
4. then after few seconds the router shows a Tick mark saying it found a device and exits search mode, at the same time the "+" stops pusling on the speedhome wifi. 
5. then the green led on the speedhome wifi blinks, but fails to establish a connection and then the led on speedhome goes red with 2 short pulse and one long pulse.

Alternatives i tried:

1. I tried connecting speedhome wifi via lan to router and then it works fine.
2. i place the speedhome wifi in the same room close to the router not very far.
3. i tried manual reset to factory settings of the speed home wifi.

Important Notes:

The firmware on both router and repeater is uptodate.

SO only when connected with lan it works well, but with wifi repeating it doesnt.

Can someone please help me out.